The Soda Jerk Works
Thanks for visiting! If you own, restore, or service vintage soda machines, you are in the right place!
Be sure to check back often, since new features and products are added frequently!
CS-64
DP111M Cavalier Coin Entry Panel Decal
Cavalier Coin Entry Panel decal for some square top ...
DP115 SERVED IN CANS
SERVED IN CANS decal found on many machines from 1960 up. ...
DP93 CAVALIER WIRING TERMINAL
Decal for color codes on Wiring terminal block on Cavalier ...
EP10 Mounting Bracket
Condenser fan motor mounting bracket. Puts motor shaft at ...
EP13A Ballast
Ballast for fluorescent lamps in square corner machines of ...
EP14 Bulb
Bulb for sold out lens in Cavalier C-27 C-33 CS-64 CS-72 ...
EP15 Wiring Harness
Main wiring harness for most Vendo and Vendolator (except ...
EP15A Compressor Lead
Compressor lead for EP15 and EP16. This is used on all ...
EP15B Cavalier Stack Harness
Wiring harness from the stack to terminal block.
EP17 Thermostat Bracket
Thermostat bracket fits most machines.
For use on ...
EP20 Solenoid
Bottle release solenoid for Cavalier, Vendo Vendolator ...
EP21A Slug Rejector
Slug Rejector AKA Coin Acceptor for Coinco units.
EP22 Micro Switch
Micro switch controlled by bottle solenoid for slant shelf ...
EP24 Start Capacitor
Start capacitor. This is a universal replacement for the ...
EP28 Lamp Socket
Flourscent lamp socket. For Vendo V-81 V-110 6-Case ...
EP50 DUCT SEAL
DUCT SEALANT. This seals the air gap where the service ...
EP8I Cavalier Fan Blade
Fan blade for Cavalier machines such as Round Top CS-72 & ...
EP9 Condenser Fan Bracket
Condenser fan motor bracket for most models mounts onto ...
HP101E Cavalier Script
Cavalier script for many square top machines. Goes near the ...
HP107J Bottle Gate Linkage Arm Rivet
Cavalier bottle stack linkage arm rivet.